ISO Boring Bars Internal

Screw clamp boring bar for holding a 80° rhombus positive insert with an inscribed circle diameter of 3/8’‘, 5/32’‘ thick (ANSI designation CC.. 32.5. ), right hand 95° side and end cutting with off-set shank, steel with coolant hole, 5/8’‘ diameter x 8’‘ long for taper boring and longitudinal boring with and without shoulder

Double clamp boring bar for holding a 80° rhombus negative insert with an inscribed circle diameter of 1/2’‘, 3/16’‘ thick (ANSI designation CN.. 43. ), left hand 95° side and end cutting with off-set shank, steel with coolant hole, 1’‘ diameter x 12’‘ long for taper boring and longitudinal boring with and without shoulder

Double clamp boring bar for holding a 80° rhombus negative insert with an inscribed circle diameter of 1/2’‘, 3/16’‘ thick (ANSI designation CN.. 43. ), right hand 95° side and end cutting with off-set shank, steel with coolant hole, 1’‘ diameter x 12’‘ long for taper boring and longitudinal boring with and without shoulder

Double clamp boring bar for holding a 80° trigon negative insert with an inscribed circle diameter of 1/2’‘, 3/16’‘ thick (ANSI designation WN.. 43. ), right hand 95° side and end cutting with off-set shank, steel with coolant hole, 1’‘ diameter x 12’‘ long for taper boring and longitudinal boring with and without shoulder

Double clamp boring bar for holding a 80° rhombus negative insert with an inscribed circle diameter of 1/2’‘, 3/16’‘ thick (ANSI designation CN.. 43. ), right hand 95° side and end cutting with off-set shank, steel with coolant hole, 1.1/4’‘ diameter x 12’‘ long for taper boring and longitudinal boring with and without shoulder

Double clamp boring bar for holding a 80° trigon negative insert with an inscribed circle diameter of 1/2’‘, 3/16’‘ thick (ANSI designation WN.. 43. ), right hand 95° side and end cutting with off-set shank, steel with coolant hole, 1.1/4’‘ diameter x 12’‘ long for taper boring and longitudinal boring with and without shoulder

Double clamp boring bar for holding a 80° rhombus negative insert with an inscribed circle diameter of 1/2’‘, 3/16’‘ thick (ANSI designation CN.. 43. ), left hand 95° side and end cutting with off-set shank, steel with coolant hole, 1.1/2’‘ diameter x 12’‘ long for taper boring and longitudinal boring with and without shoulder